Focus800 LED Torch
Rechargeable USB Powerbank
800
LUMENS
USB
RECHARGEABLE
HIGH
LOW
STROBE
MAP
FOCUS
Focus800 LED Torch
This versatile rechargeable torch offers a variety of great features and functions, including a 800 lumen output LED with three operating modes of High, Low, Strobe with a variable dimming function for precise light output control. The focus control allows the light to be adjusted from a tight spot beam to a flood light to suit the job in hand.
The torch has an integral tail light charging indicator that glows red when the battery requires charging, blue when under charge and green when fully charged. The tail light can also be switched to the Green mode for use as a night vision light for map reading applications.
A useful powerbank function is also provided that allows the torch to be used to recharge many small electronic devices such as mobile phones and MP3 players (using a suitable manufacturers charging lead).
The torch has an impressive run time of up to eight hours from its powerful internal 3.7V 2600mAh Li-ion battery that can be recharged and used time and time again.
The anodised aluminium body is lightweight and durable and the torch is water and dust proof to IP54 for use in all weather conditions.
Supplied complete with a USB charging lead and car charger unit.
Powerbank FunctionTo access the torches powerbank function cycle the tail-cap switch until the green map reading LED is illuminated, then depress the tail-cap switch twice in quick succession. The tail-cap light will flash green indicating that the powerbank function is switched on and operating.
1) Plug the USB plug into the charging port of the device to be charged.
2) Plug the USB plug into the USB outlet (A) on the side of the torch.
3) Changing will commence as soon as the USB lead is connected, check that the torch is switched off, to ensure that the recharge time is kept to a minimum.
4) Once the attached device is fully charged disconnect the charging lead to conserve the remaining battery power stored in the torch.
NOTE: The Focus 800 can be used to recharge any device that has been supplied with a USB charging lead by its manufacturer. Lighthouse cannot be held responsible for any damage or accident caused to any device that is charged using the Focus 800 as a power source.
Please note some mobile devices charging leads can contain authentication chips to prevent the use of third party chargers with their products.
| Mode | High | Low |
|---|---|---|
| Brightness | 800 lumens | 240 lumens |
| Run time | 3 hours | 8 hours |
| Beam distance | 100 metres | |
| Light source | High-performance LED | |
| Water resistant | IP54 | |
| Weight | 157g (exc batteries) | |
| Dimensions | 154mm x 37/31.8mm | |
| Battery | 3.7V 2600mAh rechargeable | |
| Charge time | 5 hours | |
| Supplied with | 3.7V 2600mAh Battery, USB charging lead, Car charger unit | |
This has to be the best torch I have ever purchased. The brightness is fantastic and its such a good compact size with so many features, especially the charging facility to power up my iPhone.
Have recommended to other friends to buy one also.
Better than my ledlenser p7 I work in high security and this is perfect to light up my patrol 5 stars to the lighthouse elite 800
Best torchlight I ever had. It has been my bike light since forever and has been used a lot with no hiccups. Battery lasts about 2 weeks of heavy use in highest setting.
Water resistant and even impact resistant.
Only bad thing is the fact that no official light house sellers are sending their products to Ireland for some reason so I guess I'll have to go for a random battery with the same specifications in amazon and pray to god.
IP RATINGSThe IP (Ingress Protection) code indicates how well a device is protected against water and dust. This is defined by the international standard EN 60529. |
|||
|---|---|---|---|
| First Digit Solids (intrusion protection) |
Second Digit Water (moisture protection) |
||
| 0 | (or X - see section below): No special protection. Not rated (or no rating supplied) for protection against ingress of this type. | 0 | (or X - see section below): No protection. |
| 1 | Protection from a large part of the body such as a hand (but no protection from deliberate access); from solid objects greater than 50mm in diameter. | 1 | Protection against vertically falling droplets, such as condensation. ensuring that no damage or interrupted functioning of components will be incurred when an item is upright. |
| 2 | Protection against fingers or other object not greater than 80mm in length and 12mm in diameter (accidental finger contact). | 2 | Protection against water droplets deflected up to 15° from vertical |
| 3 | Protection from entry by tools, wires etc, with a diameter of 2.5 mm or more. | 3 | Protected against spray up to 60° from vertical. |
| 4 | Protection against solid objects larger than 1mm (wires, nails, screws, larger insects and other potentially invasive small objects such as tools/small etc). | 4 | Protected against water splashes from all directions. Tested for a minimum of 10 minutes with an oscillating spray (limited ingress permitted with no harmful effects). |
| 5 | Partial protection against dust that may harm equipment. | 5 | Protection against low-pressure jets (6.3 mm) of directed water from any angle (limited ingress permitted with no harmful effects). |
| 6 | Totally dust tight. Full protection against dust and other particulates, including a vacuum seal, tested against continuous airflow. | 6 | Protection against direct high pressure jets. |
| 7 | Protection against full immersion for up to 30 minutes at depths between 15 cm and 1 metre (limited ingress permitted with no harmful effects). | ||
| 8 | Protection against extended immersion under higher pressure (i.e. greater depths). Precise parameters of this test will be set and advertised by the manufacturer and may include additional factors such as temperature fluctuations and flow rates, depending on equipment type. | ||
| 9K | Protection against high-pressure, high-temperature jet sprays, wash-downs or steam-cleaning procedures - this rating is most often seen in specific road vehicle applications (standard ISO 20653:2013 Road Vehicles - Degrees of protection). | ||
IK RATINGSIK ratings are defined as IK and a number from 00 to 10, this indicates the degree of protection provided by the electrical enclosures against external mechanical impacts. |
|
|---|---|
| What are the different IK ratings? | |
| IK00 | There is no Protection |
| IK01 | Protected against 0.14 joules of impact (this is the equivalent to the impact of a 0.25kg mass dropped from 56mm above) |
| IK02 | Protected against 0.2 joules of impact (this is the equivalent to the impact of a 0.25kg mass dropped from 80mm above) |
| IK03 | Protected against 0.35 joules of impact (this is the equivalent to the impact of a 0.2kg mass dropped from 140mm above) |
| IK04 | Protected against 0.5 joules of impact (the equivalent to the impact of a 0.25kg mass dropped from 200mm above the impacted surface) |
| IK05 | Protected against 0.7 joules of impact (the equivalent to the impact of a 0.25kg mass dropped from 280mm above the impacted surface) |
| IK06 | Protected against 1 joules of impact (the equivalent to the impact of a 0.25kg mass dropped from 400mm above the impacted surface) |
| IK07 | Protected against 2 joules of impact (the equivalent to the impact of a 0.5kg mass dropped from 400mm above the impacted surface) |
| IK08 | Protected against 5 joules of impact (the equivalent to the impact of a 1.7kg mass dropped from 300mm above the impacted surface) |
| IK09 | Protected against 10 joules of impact (the equivalent to the impact of a 5kg mass dropped from 200mm above the impacted surface) |
| IK10 | Protected against 20 joules of impact (the equivalent to the impact of a 5kg mass dropped from 400mm above the impacted surface) |