Boost Torch
Rechargeable
2000
LUMENS
USB
RECHARGEABLE
HIGH
LOW
STROBE
SPOT
FLOOD
DISCONTINUED
Boost Torch
The Lighthouse Elite Rechargeable Boost Torch provides a strong 1000 lumen spotlight beam that can be boosted to a powerful 2000 lumens when holding down the power button for a brief period.
It also features a COB LED floodlight that produces 500 lumens of light and can also be set to emit 100 for a longer runtime.
As well as the boost setting the spotlight has three settings of High, Low and Strobe, whilst the floodlight has two settings of High and Low.
The magnetic base and metal clip can be attached to several surfaces to aid with hands free use and the battery has a long run time of up to 10 hours.
Output Settings
Boost (Spot) - Strong solid white light (2000 lumens for 45s)
High (Spot) - Solid white light (1000 lumens)
Low (Spot) - Dimmed white light (200 lumens)
Strobe (Spot) - Flashing white light (1000 lumens)
High (Flood) - Solid white light (500 lumens)
Low (Flood) - Dimmed white light (100 lumens)
| Brightness | Up to 2000 lumens |
| Run time | Up to 10 hours |
| Beam distance | UP to 240 metres |
| Light source | LED Spotlight/COB LED Floodlight |
| Battery | 3.7v Li-ion 2000mAh (7.4wh) |
| Charge time | Variable up to 6 hours |
| Water resistant | IP44 |
| Impact resistant | 1 metre |
| Weight | 141g |
| Dimensions | 125 x 26 x 21mm |
| Supplied with | USB-C charging lead |
I picked this up from a tool shop and charged it up, took about 6 hrs in total, if you watch the video https://www.youtube.com/watch?v=Y6c5wvG6Y5o&t=10s it shows you about this wee touch, lets say about it, i was very pleased with how this worked it lit up my hole road i brought it to keep in my car, it is an amazing thing so bright i brought two more for my family who walk and with the flashing mode can be used to attract attention if needed.
In a few words, this is bloody fantastic.
IP RATINGSThe IP (Ingress Protection) code indicates how well a device is protected against water and dust. This is defined by the international standard EN 60529. |
|||
|---|---|---|---|
| First Digit Solids (intrusion protection) |
Second Digit Water (moisture protection) |
||
| 0 | (or X - see section below): No special protection. Not rated (or no rating supplied) for protection against ingress of this type. | 0 | (or X - see section below): No protection. |
| 1 | Protection from a large part of the body such as a hand (but no protection from deliberate access); from solid objects greater than 50mm in diameter. | 1 | Protection against vertically falling droplets, such as condensation. ensuring that no damage or interrupted functioning of components will be incurred when an item is upright. |
| 2 | Protection against fingers or other object not greater than 80mm in length and 12mm in diameter (accidental finger contact). | 2 | Protection against water droplets deflected up to 15° from vertical |
| 3 | Protection from entry by tools, wires etc, with a diameter of 2.5 mm or more. | 3 | Protected against spray up to 60° from vertical. |
| 4 | Protection against solid objects larger than 1mm (wires, nails, screws, larger insects and other potentially invasive small objects such as tools/small etc). | 4 | Protected against water splashes from all directions. Tested for a minimum of 10 minutes with an oscillating spray (limited ingress permitted with no harmful effects). |
| 5 | Partial protection against dust that may harm equipment. | 5 | Protection against low-pressure jets (6.3 mm) of directed water from any angle (limited ingress permitted with no harmful effects). |
| 6 | Totally dust tight. Full protection against dust and other particulates, including a vacuum seal, tested against continuous airflow. | 6 | Protection against direct high pressure jets. |
| 7 | Protection against full immersion for up to 30 minutes at depths between 15 cm and 1 metre (limited ingress permitted with no harmful effects). | ||
| 8 | Protection against extended immersion under higher pressure (i.e. greater depths). Precise parameters of this test will be set and advertised by the manufacturer and may include additional factors such as temperature fluctuations and flow rates, depending on equipment type. | ||
| 9K | Protection against high-pressure, high-temperature jet sprays, wash-downs or steam-cleaning procedures - this rating is most often seen in specific road vehicle applications (standard ISO 20653:2013 Road Vehicles - Degrees of protection). | ||
IK RATINGSIK ratings are defined as IK and a number from 00 to 10, this indicates the degree of protection provided by the electrical enclosures against external mechanical impacts. |
|
|---|---|
| What are the different IK ratings? | |
| IK00 | There is no Protection |
| IK01 | Protected against 0.14 joules of impact (this is the equivalent to the impact of a 0.25kg mass dropped from 56mm above) |
| IK02 | Protected against 0.2 joules of impact (this is the equivalent to the impact of a 0.25kg mass dropped from 80mm above) |
| IK03 | Protected against 0.35 joules of impact (this is the equivalent to the impact of a 0.2kg mass dropped from 140mm above) |
| IK04 | Protected against 0.5 joules of impact (the equivalent to the impact of a 0.25kg mass dropped from 200mm above the impacted surface) |
| IK05 | Protected against 0.7 joules of impact (the equivalent to the impact of a 0.25kg mass dropped from 280mm above the impacted surface) |
| IK06 | Protected against 1 joules of impact (the equivalent to the impact of a 0.25kg mass dropped from 400mm above the impacted surface) |
| IK07 | Protected against 2 joules of impact (the equivalent to the impact of a 0.5kg mass dropped from 400mm above the impacted surface) |
| IK08 | Protected against 5 joules of impact (the equivalent to the impact of a 1.7kg mass dropped from 300mm above the impacted surface) |
| IK09 | Protected against 10 joules of impact (the equivalent to the impact of a 5kg mass dropped from 200mm above the impacted surface) |
| IK10 | Protected against 20 joules of impact (the equivalent to the impact of a 5kg mass dropped from 400mm above the impacted surface) |